LCD screen on enVision Appliance displays a message

Fact

enVision Core 3.7.1

60 series

Symptom

"e1211 ROMB Batt" seen on LCD

Change

The appliance unit may have been turned off for a period of time, perhaps during shipment.

Cause

The battery power is low for the SCSI controller and this does not effect the operation of the system.

Fix

Follow the instructions below to recharge the battery:

1. Power down the appliance unit and unplug the power cord.

2. Plug the power cord back into the appliance but DO NOT switch it back on as this will charge the battery.

3. Let the battery charge for a minimum of three hours but the preference would be to charge the battery for twenty-four hours.

4. After charging the battery, switch the appliance unit back on and the message should clear itself.

Please contact RSA Customer Support if the problem persists.

note

Refer also to document enVision appliance RAID controller battery for adidtional information.

-Regards,

Blackhattrick blog

(Googlethewebsite.blogspot.com/blackhattrick.blogspot.com)

RSA enVISION